PROPER INSTALLATION OF COOLER MEDIA

The cooler media must be installed with the steeper flute angle slanting down toward the side of air entry. This directs more water to the inlet to provide the maximum temperature drop and to minimize water coming off the back of the pad.

 

INITIAL WASHING OF THE MEDIA

The media should be washed for several hours by running the pump without any air flow through the media. The washing action will clean out any particulate matter as well as reduce the odor and improve the wetting ability.

 

ENSURE PROPER WATER FLOW AND BLEED OFF

The media will reach it peak operation after about 100 hours of operation. The chemical constituency and rigidifying agents in the media will be the set in. Ignoring any discolor in the water. During this initial period. Run proper bleed off during this period.